VHF Radio Transmitter

VHF Radio FM Transmitter Circuit

Here’s a VHF Radio FM transmitter. This project is a simple VHF FM transmitter using only one crystal and will cover 145.00 to 146.00 MHz. The crystal is a 44.9333 MHz crystal for 145.500 receive, as used in the Trio (Kenwood) 2200, PYE, Motorolla, Tait equipment, to name but four. The frequency of the crystal is not critical as almost any other xtal for the 2-meter band will function.

VHF Radio Transmitter

No provision has been made to tune the vhf radio transmitter to different channels, as this transmitter was first used as a single channel “repeater box”, leaving my main rig free to be used on other channels. The transmitter circuit is given above and simply mixes the output of a (more or less) conventional receiver multiplier (x3) with the output of a 10.7MHz VFO that is modulated with true FM.

Ordinary 1N4001 diodes will function well as varicap diodes, but if true varicap diodes (such as BA102 etc.) are used you will have to reduce the value of the 18pf capacitor coupling D1/D2 to L1. L1 may be a 10.7MHz IF transformer robbed from a domestic receiver, but remove the internal capacitor. Adjust L1 (10.2 – 11.2 MHz) to cover 145-146 MHz.

The transmitter  modulator is a simple circuit which I will post later. Two OP-Amps were used in the prototypes, the first was a MIC amplifier to bring the MIC AF OP up to 500mV RMS. Clamp the AF with a couple of back-to-back diodes (limiter) then the second OP-Amp amplifies the clipped AF to the correct level, (about 1.5v RMS) for 5KHz deviation. Adjust the gain of the first OP-AMP for MIC GAIN and adjust the gain of the second OP-AMP for deviation (with FULL AF).

Audio Modulator

The output of the transmitter amplifier driver will supply about 10-20mW to the PA. I didn’t use a Power Amplifier because I lived so close to the repeater (path loss = -109dB). There are hundreds of VHF QRP PA’s published in SPRAT, INTERNET, RSGB books, RadCom, and PACKET RADIO so I will leave that to your own ingenuity. A single transistor, such as the 2N3866 will be more than adequate to get up to 250mW, but an additional band-pass tuned circuit should be used between them.

Browse: VHF Radio Transmitter on Amazon

See more: Wireless Transmitter

Source: FM Transmitter